WHY DON’T ANY OF THE LEDS IN A STRIP LIGHT UP?

If an entire pod does not light up it is usually an indication that the plug connector has become loose or the cable has become cut or pinched. First, inspect the entire length of the cable and LED pod for damage. If damage exists, you will need to repair or replace the LED and cable. If no damage exists check the connector plug for that LED pod. Pull the plug apart and use a volt meter to test the CPU side of the plug (female plug) when the CPU is turned ON and is set to flash mode number one. If you can detect electrical current on any of the metal tabs in the plug, the problem may exist in the plug on the LED side. Use the volt meter to test the wires as they exit the plug on the LED side (male end). If no voltage exists, the plug may need to be repaired or replaced.